LivMote is intended to be mounted on VESA 100x100 mounts, ideally tilted at an angle to capture people of varying heights properly. If you have our customized Floor Stand or Wall Mount, click on the below installation steps to see how the LivMote device is installed
<aside>
📖 Table of Contents
</aside>
Floor Stand Installation
What's included:
- Stand Pole
- Stand Base
- Stand Mount
- LivMote Device
- Power Cord
- Security Bracket
- M3 Screws & Nuts
- 20-Pin Cable
Step 1. Unscrew the 3 thumb screws from the Stand Base
Step 2. Slide the Stand Pole over the base, so the screw hole aligns
Step 3. Screw the Security Bracket onto the Stand Mount using the included M3 Screws and Nuts
Step 4. Attach the Stand Mount to the Stand Pole by using the 2 thumb screws from the Mount.
Step 5. Slide the LivMote Device onto the Security Bracket. You'll hear a click as it locks into place.
Step 6. Plug in the Power Cord and any other required cords (e.g. ethernet, 20-pin cable)
That's it! Your device is installed and ready for provisioning. Make sure to take of the protective film on the LivMote device screen.